
setup
-NIGHT¨DAY DWELL TIME : Time required to determine the fi lter switch.
-MASK AREA : If there exists a bright
spot light source in a night scene, you can specify the size and position as needed.
This will prevent an error in switching
filter, or failure to determine the fi lter switch in a night scene where a bright spot light source exists.
Any excessively bright area in a night
scene will be MASKed.
You can specify MASK 1 and 2 simultaneously.
If <BACKLIGHT> is set to <BLC>, the MASK AREA function is not available.
yEXT : The interface to an external alarm enables an automatic switch between DAY and NIGHT mode.
If you set <DAY/NIGHT> to EXT, and alarm #1 to NO/NC in ALARM SET- ALARM IN SET, the alarm can be used for an input signal in EXT mode of <DAY/NIGHT>.
If an alarm signal occurs, the mode will switch to NIGHT.
M If <DAY/NIGHT> is set to EXT, ALARM1 in ALARM OUT SET, and ALARM1 in ALARM
If you use an infrared light source while in AUTO mode, this may cause a failure in AUTO SWITCH or AUTO FOCUS.