Samsung SCC-C6453P manual Focus Mode, Zoom Speed, Display Zoom, Display P/T, Digital Zoom, Detail

FOCUS MODE

You can select a focus mode according to the angle that you adjusted for camera recording.

- AF : This will monitor the screen continuously	DAY/NIGHT	AUTO
	WHITE BAL
to focus automatically. If you adjust the focus	FOCUS MODE		ONEAF
	ZOOM SPEED	[2]
manually, that will operate the same as in
				OFF
<MF>. This will also restore focus after the	DISPLAY ZOOM
	DISPLAY P/T			OFF
operation of pan/tile/zoom.
	DIGITAL ZOOM			X16
- ONEAF : Restores focus after the operation	DETAIL	[2]
	V-SYNC			INT
of pan/tile/zoom, and operates the same as
in <MF> unless the operation of pan/tile/
zoom is executed.
- MF : You can adjust the focus manually.

M While you are working on the following objects, <AF> may not work properly. If this is the case, use <MF> instead.

-Very bright object, or dominant object in a dark scene

-Object against the rear side of a moist or dirty glass

-A scene where nearby and distant objects co-exist

-White wall or single-colored object

-Venetian blinds and other horizontally striped objects

ZOOM SPEED

You can adjust the zoom operation speed.

DISPLAY ZOOM

You can set to display the zoom status on the screen.

It will disappear in about 3 seconds if the zoom factor has no further change.

DISPLAY P/T

You can set to display the operation status of pan/tilt when it is active.

It will disappear in about 3 seconds if the pan/tilt position has no further change. However, the allowable error is ±2°.

DIGITAL ZOOM

You can set the maximum allowable digital zoom ratio.

Digital Zoom will start operation after it is zoomed in to the maximum optical ratio of x43. If you set DIGITAL ZOOM to x16, you can take a shot at up to x688 (43x16).

DETAIL

Used to adjust the vertical and horizontal distinction, respectively.

English

English _31