Samsung SCLSeries manual Pressure, Board

NO ITEMS TEST CONDITION PERFORMANCE

WHEN OPERATING AT HIGH TEMPERATURE RANGE FROM 85℃ to 125℃, THE

OPERATION SHALL BE CARRIED OUT AT A DERATED VOLTAGE OR LESS

DERATING VOLTAGE Vt AT ANY TEMPERATURE BETWEEN 85℃ AND 125℃

SHALL BE CALCULATED BY THE FOLLOWING EQUATION

	VOLTAGE	100
	DERATING %	80
		60
		40
8	DERATING	20
	VOLTAGE	0
		-55	0 20	85	125

OPERATING TEMPERATURE

=Vr − Vr − Vd (T − 85) 40

	WHERE Vt : DERATED VOLTAGE AT ANY TEMP. BETWEEN 85									to 125
									℃		℃
	Vr : RATED VOLTAGE
	Vd : DERATED VOLTAGE AT 125
								℃
	APPLY PRESSURE IN THE DIRECTION OF THE								THERE SHALL BE NO
	ARROW AT A RATE OF ABOUT 0.5MM/SEC. UNTIL IT								EVIDENCE OF
	REACHES A BENT WIDTH OF 3MM AND HOLD FOR 30								MECHANICAL DAMAGE.
	SEC. THE TEST BOARD SHALL BE IEC 40(S) 541. FOR								ELECTRICAL
	OTHER PROCEDURES REFER TO IEC 40(S) 541.								CHARACTERISTICS
									SHALL SATISFY THE
				Pressure		rod			INITIAL REQUIREMENT.
			10						IF THERE ARE
	ELECTRODE								ELECTRODES ON BOTH
					20
9	(TERMINAL						Board		SURFACES, IT SHALL
	STRENGTH)								SATISFY THE ABOVE
									REQUIREMENT ON
									WHICHEVER SURFACE
									IT MAY BE FIXATED ON.
		45		2		45	2
		±				±

SCL Series