DIGITAL VIDEO RECORDER
GB |
| GB |
|
6Alarm Record Setup
➄ DISK END BUZZER | The following illustrates the intial setting of the ALARM RECORD SETUP menu. | ||||
If set to ON, the Buzzer will sound when the HDD is full during the recording; if set to |
|
|
|
| |
OFF, the Buzzer will not sound. [ON/OFF] |
| ALARM RECORD SETUP |
|
| |
|
|
|
| ||
|
|
|
|
| |
|
| ALARM ENABLE | OFF | ||
➅ RECORD TIME MARK |
| ALARM DETECT TYPE | N.O. | ||
| ALARM BUZZER | ON | |||
|
| MAIN ALARM TIME | 10SECOND | ||
If set to ON, the recording time will be displayed during playback; if set to OFF, it will not |
| PRE ALARM TIME LIMIT | 2SECOND | ||
| POST ALARM TIME LIMIT | OFF | |||
|
| ||||
be displayed. [ON/OFF] |
| MAIN ALARM PICTURE RATE | 30.00FPS | ||
| MOTION DETECTION | OFF | |||
|
| SET AREA & SENSITIVITY |
|
| |
➆ STATUS DISPLAY |
|
|
|
| |
|
|
|
| ||
Set the location on the screen where the time of recording will be displayed during | ① ALARM ENABLE |
|
| ||
playback. Set to LEFT to display it on the bottom left of the screen, or set to RIGHT to |
|
| |||
You shall select ON to start recording in the event of alarming and select OFF to prevent | |||||
display it on the bottom right of the screen. [LEFT/RIGHT] | |||||
recording in the event of alarming. If you set the ALARM ENABLE to ON and exit the menu, | |||||
| the system will begin recording whenever alarm occurs. To force stop the recording during the | ||||
| alarm recording, press and hold the STOP(■) button for 3 seconds. Then, the recording by the | ||||
| current alarm will be stoppted, and the alarm recording will not be performed for the next 5 | ||||
| seconds even if alarm occurs. To completely stop the alarm recording, go into the menu | ||||
| within that 5 seconds to set the ALARM ENABLE to OFF. If no action is performed by the | ||||
| user for 5 seconds, the system returns to the alarm recording mode. [ON/OFF] | ||||
| ② ALARM DETECT TYPE |
|
| ||
| Set to N. C. (Normally Close) when the alarm input is Active High, and set to N.O.(Normally | ||||
| Open) when the alarm input is Active Low. [N.C./N.O.] | ||||
| ➂ ALARM BUZZER |
|
| ||
| Set to ON to have the system activate the Buzzer when a motion is deteced in the input | ||||
| video or when alarm occurs, or set to OFF to keep the Buzzer inactive. [ON/OFF] | ||||
| ➃ MAIN ALARM TIME |
|
| ||
| Set the duration for which alarm recording is to be performed when a motion is detected in the | ||||
| input video or when alarm occurs. The value can be set from 0 seconds to 5 minutes when you | ||||
| set to OFF. If you set to AUTO, the alarm recording is performed only during when the alarm | ||||
| signal is Active. |
|
| ||
| [5MINUTE/4MINUTE/3MINUTE/2MINUTE/1MINUTE/30SECOND/20SECOND/ | ||||
| 10SECOND/AUTO/OFF] |
|
| ||
|
|
|
|
| |