DIGITAL VIDEO RECORDER
GB |
|
| GB |
| 9 | ||
8 |
| ||
| System Setup | Communication Setup | |
The following illustrates the intial setting of the SYSTEM SETUP menu.
SYSTEM SETUP
PASSWORD | **** |
PASSWORD LOCK | OFF |
HDD ERASE | OFF |
FACTORY RESET | OFF |
MENU SCREEN | DARK GRAY |
LANGUAGE | ENGLISH |
①PASSWORD
Set the system password. You can enter a
②PASSWORD LOCK
If you set this to ON, you can ask for a password, which is set in the PASSWORD, each time the MENU button is pressed or the recording lock cancellation is attempted during the recording, and stop the respective operation if wrong password is entered. If set to OFF, you do not have to enter password for each case metioned above. [ON/OFF]
➂HDD ERASE
If you set to ON and exit the menu, the system will delete all data stored on the HDD. [ON/OFF]
Caution
Verify once again that is is OK to delete the data, as deleted data cannot be restored.
➃FACTORY RESET
If you set to ON and finish the menu, all settings will be restored to their factory default settings. However, the data on the HDD will not be deleted. [ON/OFF]
➄MENU SCREEN
If this is set to DARK GRAY, the background of the screen becomes darker when the MENU button is pressed and you will not be able to see the characters clearly. If set to OFF, you can see the current video clearly even when the MENU button is pressed. [DARK GRAY/OFF]
➅MULTIPLEXER SELECT
The settings of all recording modes will be dependent on the Multiplexer setting. The corresponding Multiplexers are SAMSUNG
➆LANGUAGE (MULTI-LANGUAGE SUPPORT)
Besides English,
[ENGLISH/DEUTSCH/FRANÇAIS/ESPAÑOL/ITALIANO]
The following illustrates the intial setting of the COMMUNICATION SETUP menu.
COMMUNICATION SETUP
BAUD RATE | 115,200 |
| ||
NETWORK ACCESS | ON |
|
|
|
IP ADDRESS | 0. | 0. | 0. | 0 |
GATEWAY | 0. | 0. | 0. | 0 |
SUBNET MASK | 0. | 0. | 0. | 0 |
NETWORK USER ID | **** |
|
|
|
NETWORK USER PWD | **** |
|
|
|
PAN/TILT TYPE |
| |||
|
|
|
|
|
①BAUD RATE
Sets data transmission rate in
[4,800/9,600/19,200/38,400/115,200]
②NETWORK ACCESS/IP ADDRESS/GATEWAY/SUBNET MASK
If the system is connected to a LAN, it can be controlled from the remote surveillance pro- gram installed on a remote PC. To connect to a LAN, set the NETWORK ACCESS to ON, and configure the IP ADDRESS, GATEWAY, SUBNET MASK, etc. to suit the user’s net- work environment. Then, connect the LAN Cable to the LAN Cable connection terminal on the back of the system and reboot the system. If at least one from the IP ADDRESS, GATEWAY, and SUBNET MASK is modified, the system must be rebooted to apply the modified setting to the system.
➂NETWORK USER ID/NETWORK USER PWD
In order to access the system through a LAN from a remote surveillance program installed on a remote PC, the user ID and password must be entered. At this time, the user ID and password entered match the ones set in the NETWORK USER ID and NETWORK USER PWD, you can connect to the system; otherwise, you cannot gain access. Both are
➃PAN/TILT TYPE (Remote Control of Camera)
You can control the Pan/Tilt/Zoom function of a camera with the remote monitoring program installed in the remote PC through LAN. Then, you shall select the camera to be controlled. But, this remote control shall be applied only to SEC
