Power Supply
Use the screwdriver to connect each line of the power cable to the corresponding port of the camera.
J | Be careful not to reverse the polarity when you connect the power cable. |
You can also use a router featuring PoE (Power over Ethernet) to supply power to the camera. |
STATIC IP SETUP
Manual Network Setup
Run <IP Installer.exe> to display the camera search list.
At the initial startup, both [Auto Set] and [Manual Set] will be grayed out.
M | For cameras found with the IPv6 setting, these buttons will be grayed out as the cameras do not |
support this function. |
1.Select a camera in the search list.
Find the MAC (Ethernet) address labeled on the rear of the camera.
Both the [Auto Set] and [Manual Set] buttons will be activated.
2.Click [Manual Set].
The MANUAL SET dialog appears. The default values of <IP Address>,
<Subnet Mask>, <Gateway>, and <HTTP Port> of the camera will be displayed. The default <PASSWORD> is 4321.
3.In the <ADDRESS> pane, provide the necessary information.
MAC (Ethernet) Address : The MAC (Ethernet) address of the applicable camera will be set automatically so you don't need to input it manually.
8
|
