Installing the camera on the ceiling

Before installation, you have to be familiar with the cautions on page 14 and fill in the holes that are not used for installation. The holes that are not used should be tightly sealed up using the screws provided for waterproofing. (Refer to page 14)

To install your camera bottom on a pipe

1 Attach the provided template to the place to be installed and penetrate a hole (5mm diameter, minimum depth 35mm) for fixing your camera to insert the provided plastic anchor (HUD 5) to the full.

2 After connecting both power and video cables, put them in order not to have damage during installation.

3 Remove the Dome cover. For more information, see step 2 in “To install your camera bottom on a pipe” on page 16.

4 Install your camera. After aligning the hole where the plastic anchor is inserted with the camera installation hole, make tight four ASSY screw-tappings where O-rings are inserted. (If no O-rings are inserted, water leak may happen.)

5 Adjust the camera lens direction. For more information, see page 20, “Adjusting the camera direction.”

6 Attach the Dome cover. For more information, see step 3 in “To install your camera bottom on a pipe” on page 16.

In case of wiring after penetrating a hole on the installation site

1 Penetrate a wiring hole toward the pipe. (Recommended hole size: within 30mm diameter)

2 Attach the gasket on the bottom of the product as shown below. You have to correctly align the hole with the pipe hole.

If the hole deviates from the gasket, water leak may happen.

Gasket

18_ Installation and Connection