The projector has been designed so that the projector does not work if the lamp cover is not completely assembled after a lamp replacement. If the projector does not work properly, please check the operating status

of the indicator LED.

Contains Mercury, Dispose According to Local, State or Federal Laws

Lamp Replacement Procedure

Since the lamp is a high temperature and high voltage product, wait at least one hour from the time that the power cord is disconnected before replacing it.

The lamp is located on the left side of the projector (when looking from the front).

Remove the screw shown in the figure below and than open the cover.

Remove the two (2) screws shown in the figure below.

Hold and pull the lamp handle out of the projector, as shown in the figure below.

Assembling a new lamp is in the reverse order of the disassembly.

Replacing and Cleaning the Filter

Precautions when replacing the projector filter

The filter is located at the bottom of the projector.

Turn off the power of the projector, and then disconnect the power cord after the heat of the projector is cooled sufficiently.

Otherwise, its parts may be damaged due to internal heat.

When replacing the filter, dust may occur.

For inquiries on Filter purchase, please refer to 'Contact SAMSUNG WORLDWIDE'.

The sequence for replacing or cleaning the filter of the projector.

Turn off the power of the projector, and then disconnect the power cord after the heat of the projector has cooled sufficiently.

Place the product so that its

Replace or clean the filter.

bottom looks upward, and than

 

push and remove the filter cover in

 

the direction of the arrow.

 

* When placing the product with

 

the bottom upwards, make sure to

 

place a soft cloth on the floor to

 

prevent scratches.

 

When cleaning the filter, use a small vacuum cleaner for computers and small electronics products, or wash it under running water.

When washing the filter under running water, make sure to dry it completely. The moisture may cause the filter to corrode.

Page 35
Image 35
Samsung SP-L300 manual Lamp Replacement Procedure, Replacing and Cleaning the Filter