Samsung SPD-3300 instruction manual Initialization Setting, Status

Functional Description

6) Initialization Setting

•Initialization Menu

Main Menu	Initialize
Camera Setting	Power ON Reset
Sequence Setting	Factory Default Set
P/T Setting	Camera Default Set
OSD Setting	Auto Refresh OFF
Alarm Setting
Initialize
Status
Power On Reset	: Camera is initialized into the original status of power
	input.

Factory Default Settings : Camera is initialized into the factory default settings. Data including Preset is deleted. This function is used for initialization all settings.

Camera Default Settings: If only the camera module is replaced due to camera module failure, the new camera module can be set up with the settings of the old camera module.

Auto Refresh : The electric circuit and the status of the equipment parts within the camera are optimized regularly. (The cycle can be set up.) If camera faces toward a certain source of light or if the settings cannot be kept because of the long time rotation filming of a certain area, the Auto Refresh function is used to maintain and re-set the existing camera settings. Default setting is OFF.

OFF, 1-7 Days : This function is disabled in the OFF mode. 1-7 Days enables the Auto Refresh operation in the interval of the selected days. Auto Refresh takes less than 10 seconds. The message “Auto Refresh” disappears after finishing the operation.

7) Status

The status of dome camera setting is displayed.

Main Menu	Camera Status
Camera Setting	CAM MODER	= 30NC
Sequence Setting	CAM VERSION	= 03.06
P/T Setting	DOME VERSION	= 00.18
OSD Setting	CON PROTOCOL	= SAMSUNG TW
Alarm Setting	DOME ID	= 001
Initialize	CONTROLLER	= Duplex-9600
Status

Cam Model = 30NC	Camera Model
Cam Version = 03.06	Camera S/W Version
Dome Version = 00.01	Control Board S/W Version
Dome ID=001	Dome Camera ID
Controller=Duplex-9600	Communication Mode Setup

ENGLISH

SPEED DOME CAMERA 58 User’s Manual SPEED DOME CAMERA 59 User’s Manual