Network Connection
Network Connection - Cable
Cable Connection for a DHCP Environment
The procedures to set up the network using Dynamic Host Configuration Protocol (DHCP) are described below. Since an IP address, subnet mask, gateway, and DNS are automatically allocated when DHCP is selected, you do not have to enter them manually.
|
| TV Rear Panel |
The Modem Port |
|
|
on the Wall | External Modem |
|
| (ADSL / VDSL / Cable TV) |
|
| 1 | LAN Cable |
2 | Modem Cable |
|
1.Connect the [LAN] port on the rear panel of the TV and the external modem with a LAN Cable.
2.Connect the LAN port on the wall and the external modem with a Modem Cable.
You can connect the LAN via a Sharer (Router).
IP Sharer
The Modem | External Modem |
Port on the Wall | (ADSL / VDSL / Cable TV) |
TV Rear Panel
LAN Cable
LAN Cable
Modem Cable
You can connect the LAN port and the TV directly depending on your network status.
TV Rear Panel
The LAN Port on the Wall
LAN Cable
NThe terminals (the position of the port and the type) of the external device may differ depending on the manufacturer. N If the IP address allocation by the DHCP server has failed, turn the external modem off, turn it on again after at least 10
seconds and then try again.
N For the connections between the external modem and the Sharer (Router), refer to the owner’s manual of the corresponding product.
N You can connect the TV to the LAN directly without connecting it through a Sharer (Router).
N You cannot use a
English - 26
