M a i n t e n a n c e
Clearing Blockages
Disconnect cleaner from electrical outlet.
The hose on the back of the vacuum cleaner that carries the dirt from the nozzle to the Dirt Cup can sometimes become clogged. If you notice a change in the sound of the vacuum motor, check for blockages.
|
|
|
Remove Dirt Cup and check Upper Tank and Louvers. Check to make sure Louvers are Installed correctly. To unlock the Louvers, grasp the rim and turn Toward the left. Pull straight down to remove. If the Louvers are missing or not locked into place, check and clear the tube in the center of the Dirt Cup.
Remove the Hose and disconnect the Wand.
Check for clogs in the vacuum base, the wand, the hose and the suction inlet.
If the blockage persists, turn the vacuum cleaner off and unplug it. Remove the bottom plate. Lift up the short hose in the base of the vacuum. Inspect the hose for clogs and remove any obstructions. Replace the short nozzle hose and the bottom plate.
Mini Turbo Brush
Use for upholstered furniture, carpeted stairs and
|
Brush bar Replacement
Remove the tool from the hose, and turn upside down. Slide the switch to unlock position.
|
Remove bottom plate. And remove brushbar and discard.
Inspect belt to ensure that it is in good condition. If broken or cracked, please replace. (See below for details.)
|
With the curved ends facing down, slide end plates of brushbar into slots on the tool. To replace bottom plate, insert the four tabs on edge of bottom plate into slots on front of tool. Pivot bottom plate down and snap closed.
|
Belt Replacement
Grasp turbine and pull firmly to remove.
Remove belt from turbine pulley.
Replace with new belt.
|
With flat sides of turbine retainers pointing down, slide retainers into grooves in tool housing and snap into place.
Replace brushbar and bottom plate.
|
Cleaning Brushbar
•Cut off pet hairs or threads surrounding brush by using scissors.
7
