Onkyo SR805 Error Messages, When the calculations are com, Plete, the following screen

First Time Setup—Continued

7

ENTER

ENTER

After the 6th or 7th measurement, the following screen appears.

Auto Speaker Setup AUDYSSEY

Please select “Next”, when measuring next position, and select “finish”, when ending.

Next finish(Calculate)

Use the Up and Down [ ]/[ ] buttons to select an option, and then press [ENTER].

Review SP Distance: Review the

speaker distance settings (see “Reviewing the Results” on page 59).

Review SP Level: Review the speaker level settings (see “Reviewing the Results” on page 59).

Cancel: Cancel the automatic speaker setup.

10	If you selected “Save,” the results are
	saved, and the following screen
	appears.

Next: Select this if you want to mea- sure another listening posi- tion. After the 8th measurement has been taken, the procedure automatically proceeds to step 8.

Finish (Calculate): Select this if you

don’t want to measure any more listening positions and are ready to calculate the results, then go to step 8.

8	When the measurements are
	complete, the following screen
	appears.
		Auto Speaker Setup	AUDYSSEY
		Calculating...

9	When the calculations are com-
	plete, the following screen
	appears.
	ENTER
	Auto Speaker Setup AUDYSSEY

Save

Review SP Config

Review SP Distance

Review SP Level

Cancel

ENTER

Use the Up and Down [ ]/[ ] buttons to select an option, and then press [ENTER].

Save: Save the calculated settings and exit the automatic speaker setup.

Review SP Config: Review the

speaker configuration settings (see “Reviewing the Results” on page 59).

Auto Speaker Setup AUDYSSEY

Saving...

11	Disconnect the setup micro-
	phone.
		Auto Speaker Setup	AUDYSSEY
		Please unplug microphone.

Notes:

•When the automatic speaker setup is complete, the Equalizer Settings (page 91) will be set to Audyssey.

•You can cancel the automatic speaker setup at any point in the procedure simply by disconnecting the setup microphone.

Error Messages

During the automatic speaker setup, one of the following error messages may appear:

Ambient noise is too high

Auto Speaker Setup AUDYSSEY

Ambient noise is too high.

Retry

Cancel

This message appears if there’s too much background noise and the measurements cannot be performed prop- erly. Remove the source of the noise and try again, or cancel the automatic speaker setup.

57