Onkyo SR805 Turn on the AV receiver, Connected TV, Place the setup microphone at, Jack, Appear

First Time Setup—Continued

1		Turn on the AV receiver and the
		connected TV.
		On the TV, select the input to which the
		AV receiver is connected.
2		Place the setup microphone at
		the 1st measurement position,
	SETUP MIC
		and connect it to the SETUP MIC
		jack.
				Auto Speaker Setup	AUDYSSEY
				Please place microphone at center
				of listening area at ear height.
				Push Enter : Next
		Notes:
		• Make sure the microphone is hori-
			zontal.
		• If there’s an obstacle between the
			microphone and any speaker, the
			automatic setup will not work cor-
			rectly. Set up the room as you would
			when enjoying a DVD movie.
		• Positioning the microphone close to
			where your ears would normally be
			will provide the best results. You can
			set the height of the microphone by
			using a tripod or level table.
3		Press [ENTER].
				Auto Speaker Setup	AUDYSSEY
				Do not unplug microphone.
				Please keep quiet.
				Now Measuring...
		A test tone is output by each speaker in
		turn, as Audyssey MultEQ XT deter-
		mines which speakers are connected.
		This takes a few minutes.
		Note:
		• If any extraneous noise is picked up
			by the microphone, the automatic
			setup may not work correctly, so
			keep quiet.

4		The speaker detect results
		appear.
	ENTER	Auto Speaker Setup			AUDYSSEY
		-----SP Detect Result-----
		FL : Yes		FR : Yes
		SL : Yes		SR : Yes
		SBL : Yes	SBR : Yes
		C : No		SW : Yes
	ENTER	Next
		Retry
		Cancel
		“Yes” means that the speaker was
		detected. “No” means that no speaker
		was detected.
		If you agree with the results, use
		the Up and Down [		]/[	] but-
		tons to select Next, and then
		press [ENTER].
		The options are:
		Next: Proceed to the next step.
		Retry: Return to step 2 and try again.
		Cancel: Cancel the automatic speaker
		setup.
5		The following screen appears.
		Auto Speaker Setup			AUDYSSEY
		Please place microphone at
		2nd Position at ear height.
		Push Enter : Next
		Place the setup microphone at
		the next position (see page 55),
		and then press [ENTER].
		Audyssey MultEQ XT performs more
		measurements. This takes a few min-
		utes.
		Auto Speaker Setup			AUDYSSEY
		Do not unplug microphone.
		Please keep quiet.
		Now Measuring...
6		When prompted, place the setup
		microphone at the next position,
		and repeat step 5.

56