Onkyo SR805 Listening Mode Presets, Dolby Digital Settings, Theater-Dimensional Setting

Adjusting the Listening Modes—Continued

Dolby Digital Settings

■Dolby EX

This setting determines how Dolby EX signals are han- dled. If you’re not using any surround back speakers, or Powered Zone 2 is being used (page 101), this setting is unavailable.

Auto: When the source is Dolby EX, you can select the Dolby EX or THX Surround EX listening mode.

Listening Mode Presets

On the Listening Mode Preset menu, you can specify a default listening mode for each of the audio formats sup- ported by each input selector. The AV receiver will then select the listening mode automatically depending on the format of the input signal. You can still select the other listening modes, although the default listening mode will be used the next time you turn on the AV receiver.

Manual: When the source is Dolby EX, you can select any of the listening modes compatible with this format (e.g., Dolby EX, Dolby Pro Logic IIx, etc.).

T–D (Theater-Dimensional) Setting

■Listening Angle

With this setting, you can optimize the Theater-Dimen- sional listening mode by specifying the angle of the front left and right speakers relative to the listening position. Ideally, the front left and right speakers should be equi- distant from the listening position and at an angle close to one of the two available settings.

		INPUT SELECTOR
		MACRO
	1		2			3			ZONE3
		REMOTE MODE
	DVD	VCR			CD				ZONE2
					CDR/MD
	TV	CABLE			DOCK				RECEIVER
		SAT							TAPE/AMP
	DIMMER								SLEEP
				ENU	M	EN
		M					U
		OP
		T
ENTER	+
	CH			ENTER					VOL
	DISC
	ALBUM
	-	G
				UIDE	IT
SETUP	CH				EX
		ETUP			RETU
	PREV	S						N
						R
	DISPLAY								MUTING
	REC			PLAYLIST					RANDOM
		LISTENING MODE

RECEIVER

Front left speaker	Front right speaker
	30˚

1 RECEIVER	Press the [RECEIVER] REMOTE
	MODE button, followed by the
	[SETUP] button.
	The main menu appears onscreen.
S
E
T
UP

Narrow: Select if the angle is less than 30 degrees. Wide: Select if the angle is greater than 30 degrees.

LFE Level Settings

With these settings, you can set the level of the LFE (Low Frequency Effects) channel individually for Dolby Digital, DTS, and multichannel PCM sources. The level can be set to –∞, –20 dB, –10 dB, or 0 dB (default).

If you find that low-frequency effects are too loud when using one of these sources, change the setting to –20 dB or –∞dB.

■Dolby D

Sets the level of the LFE channel for Dolby Digital sources.

■DTS

Sets the level of the LFE channel for DTS sources.

■Multich PCM

Sets the level of the LFE channel for multichannel PCM sources. (Multichannel PCM is input via HDMI.)

2

ENTER

ENTER

Use the Up and Down []/[ ] buttons to select “5. Listening Mode Preset,” and then press [ENTER].

The Listening Mode Preset menu appears.

5.Listening Mode Preset

1.DVD

2.VCR/DVR

3.CBL/SAT

4.GAME/TV

5.AUX1

6.AUX2

7.TAPE

8.TUNER

9.CD

10.PHONO

84