Troubleshooting, Problem, Possible solution

Troubleshooting

Check this list of possible problems and solutions before bringing your vacuum to a service center.

CLEANER WON’T TURN ON

•Not firmly plugged in.

•No voltage in wall plug.

•Blown fuse or tripped breaker.

•On/Off switch not turned on.

CLEANER WON’T PICK UP

•Plug unit in firmly.

•Check fuse or breaker.

•Replace fuse or reset breaker.

•Slide to on.

•Tighten the screw of the handle.

•Circuit breaker tripped.

•Agitator brush rolls worn.

•Dirt cup full.

•Incorrect carpet height setting.

•HEPA cartridge filter clogged.

•Pre-filter clogged.

•Dirt cup not properly installed.

•Filter assembly not assembled properly.

•Blockage in hose(or air flow passage).

•Broken belt.

•Hose not inserted fully.

ABNORMAL SOUND

•Strange sound like air rushes

•Reset circuit breaker.

•Replace brush rolls.

•Empty dirt cup.

•Move nozzle control knob to lower settings.

•Clear HEPA cartridge filter by either tapping the side of the dirt cup.

•Clean pre-filter.

•Position dirt cup properly.

•Ensure that filter assembly is positioned properly.

•Clear blockage.

•Replace belt.

•Insert hose.

•Check for clogs.

This Vacuum cleaner is approved the following.

EMC Directive: 89/336/EEC, 92/31/EEC and 93/68/EEC

Low Voltage Safety Directive: 73/23/EEC and 93/68/EEC