10
Reposition Brush cover and eight screws. Tighten screws securely. Snap end of Brush cover into place.
Turn rotating Floor Brush by hand several times in direction of motor pulley, if properly installed, Drive Belt will center itself.
Place ends of rotating Floor Brush down into slots on sides as shown.
3 Place new Drive Belt over motor pulley and stretch other end over rotating Floor Brush in the space between the bristles.
4
5
6
10Clean strings, hair and other debris from Motor Pulley and Drive Belt areas. 11Check Drive Belt carefully for wear, cuts or stressed areas.
12Check Air Passageway for obstructions. Remove debris from this area.
Replace Drive Belt
1 Unplug cleaner from electrical outlet.
2 With Rotating Floor Brush removed from vacuum cleaner(Step1-7 of Check Rotating Floor and Drive Belt) grasp old Drive Belt and remove from Motor pully. Discard old Drive Belt.
Maintenance
Check Rotating Floor Brush and Drive Belt
You should check your vacuum cleaner’s Rotating Floor Brush and Drive Belt regularly for wear or damage. You should also clean the brush and brush ends of strings, hair, and carpet fibers. These can wrap around the brush and hamper its ability to effectively clean your carpet. Also remove any debris that has accumulated under the brush cover.
1 Unplug cleaner from electrical outlet.
Place handle in Low position.
Remove the four screws as shown with a screwdriver.
Turn over the cleaner.
Remove the eight screws, and turn over the cleaner again.
Lift the cover-Brush off.
Remove the three screws on the case-drum.
Grasp Rotating Floor Brush at both ends and lift.
Clean strings, hair and other debris from Rotating Floor Brush, paying particular attention to brush ends.
