Tuning Your Television for the VCR
STANDBY/ONEJECT
2SLOW |
SHUTTLE
IPC
4
OK
You must tune your television for the VCR only if you are not using a Scart cable
➢To view pictures from your VCR when a Scart cable is used, the television must be set to the audio/video mode (AV).
1Switch on the television.
2Switch on the VCR by pressing STANDBY/ON on the front of the VCR or STANDBY/ON on the remote control.
3Select a programme position on the television to be reserved for use with your VCR.
4Insert the video cassette in the VCR. Check that the VCR starts reading the cassette; if not, press ❿II button.
5Start a scan on your television or set the television to UHF channel 36.
6Fine tune the television until the pictures and sound are obtained clearly.
7If you cannot find the pictures and sound, or there is interference from nearby channels, it may be necessary to change the setting of the VCR output channel (see Solving Problems section of this manual).
8When the picture and sound are perfectly clear, store this channel at the desired programme position on the television.
Result: That programme is now reserved for use with your VCR.
14
