Upgrading the Firmware Flash Memory
5
The product firmware can be upgraded by downloading the updated file from the
following Web site:
http://www.samsungodd.com
Before you install the CD-R/RW drive, we strongly recommend that you
check that your setup meets the system requirements listed below.
System RequirementsItem Description
Computer Intel Pentium II (orhigher), 32 MB of RAM (or higher)
with an E-IDE interface
Disk space 700 MB minimum
Windows version Windows 95 / 98 OSR2 / 2000 / ME or XP /
Windows NT 4.0 (or higher)
Your CD-R/RW Drive4
1234
5
6
123 4 5
1. Connector for stereo headphones with a 3.6 mm stereo mini-jack
2. Headphone volume control
3. Emergency eject hole (if the compartment does not open when
you press the Eject button, power off the computer, insert a pin or
unfolded paper clip in the holeand push firmly)
4. Indicator light (when it is green, a disc is being read or recorded)
5. Disc compartment (the compartment opens and closes
automatically when you press the Eject button)
6. Eject button
1. Two-pin digital audio output terminal for use with a sound or MPEG
card supporting digital audio features
2. Four-pin sound output terminal for use with a sound card
(refer to the sound card documentation for further details)
3. Master/slave select terminal
4. 40pin host E-IDE interface connector
5. 4pin power terminal
General DMA Installation GuideWindows 95/98/MeImportant!
Please read the entire DMA installation guide before installing your CD-R/RW drive.
About DMA Installation
For stable writing performance at high speeds, Installation of DMA transfer mode for
E-IDE/ATAPI interface is strongly recommended.
We recommend DMA mode for fast writing.
DMA Setting
Before you install your CD-R/RW drive, we recommend to set DMA to enabled on
your PC system. See the following procedure to set DMA transfer mode in windows
oprerating system. (Windows 95 OSR2/98/ME)
●Click on START
●Click on Settings
●Select Control Panel
●Select the System Icon
●Select the Device Manager panel
in System Properties
●Expand the CD-ROM icon
●Select your CD-R/RW drive
●Click on the Properties button
●Click on the Settings tab
●Check the DMA checkbox to enables DMA.
●Click OK
●Restart your PC
www.samsungelectronics.com
Windows 2000/XP
Select the DMA mode by selecting [Start > Setting > Control Panel > System >
Device Manager > IDEATA/ATAPI Controller > Default/Assistant IDE Channel
Advanced Information]
SW-224_eng-02 12/19/01 4:42 PM Page 4