- IF YOU HAVE A PROBLEM

PROBLEM

CAUSE

REMEDY

Motor does not start.

No power supply.

Check cable, plug and

Thermal cut-out.

socket. Leave to cool.

 

Suction force is gradually

Nozzle, suction hose or

Remove the object.

decreasing.

tube is blocked.

 

Cord does not rewind fully.

Check that the cord is not

Pull the cord out 2-3m and push

twisted or wound unevenly.

down the cord rewind button.

Vacuum cleaner does not

Crack or hole in hose.

Check hose and replace

pick up dirt.

if required.

 

Thermal protector : This vacuum cleaner has a special thermostat that protects the motor in case of its overheating. If the vacuum cleaner suddenly shuts off, turn off the switch and unplug the vacuum cleaner. Make sure that there is power in the socket.

To avoid electric shock, please contact a qualified electrician. Check the vacuum cleaner for possible source of overheating such as a full dust tank, a blocked hose, pipe, or clogged filter. If these conditions are found, fix them and wait at least 30 minutes before attempting to use the vacuum cleaner. After the 30 minute period, plug the vacuum cleaner back in and turn on the switch.

If the vacuum cleaner still does not run, contact a service engineer.

This Vacuum cleaner is approved the following.

EMC Directive : 2004/108/EEC

Low Voltage Safety Directive : 2006/95/EC

WARNING : This vacuum cleaner is designed for household use only.

Do not use this vacuum cleaner to clean building waste and debris, toner of laser printer. Regularly keep the filters in clean conditions to prevent of collecting fine dust in them. Dry carpet cleaners or fresheners, powders and fine dust such as flour should be only vacuumed in very small amounts.

Always clean the dust bin & filters after vacuuming them.

Do not use this vacuum cleaner with any of the filters or dust bin removed. Do not use worn, deformed or damaged filters.

Always install the filters in the correct position as shown in this manual. Failure to meet these requirements could cause damage to the internal parts and void your warranty. Never twist micro filter after washing. It can be a reason of deformation or damage filter. If filter deformed or damaged please replace the filter (it can be a reason of penetration of dust and debris into motor). Please insert filter properly without gap between filter and cover filter (it can be a reason of penetration of dust and debris into motor).

EN-9

DJ68-00471P-10.indb 9

2017. 5. 31.

 

�� 3:40