Automatic charging
Recharging |
1. SR10M701✴✴✴ Series
If the battery indicator blinks at 0.4 sec. intervals, the POWERbot will automatically return to the docking station to be charged.
2. SR10M70✴✴✴✴ / SR2070✴✴✴✴ Series
When the battery indicator blinks during cleaning, the POWERbot will return to the docking station to charge itself automatically.
You can command the POWERbot to recharge at the docking station while it is in cleaning.
Low battery (Lo)
Manually charge the POWERbot by placing it on the docking station.
Steps to take if recharging not occuring:
Check the installation status of the docking station when:
ffthe docking station is located in a place where the POWERbot cannot easily access it.
ffthe distance between the docking station and POWERbot is over 5 m.
Manually charge the POWERbot when:
ffthe docking station is located in a corner ffthe battery is fully exhausted
ffthe POWERbot is immobilized by an obstacle (furniture etc.)
ffthe POWERbot can't climb a threshold near the docking station (The maximum height of a threshold the POWERbot can climb is about 1.5 cm.)
ffwhen the battery indicator blinks and "Lo" is displayed
ffwhen the battery indicator blinks (Applicable to SR10M701✴✴✴ Series)
ffwhen the POWERbot is set to the Spot clean or Manual clean mode
