PROBLEM | SOLUTION |
Fills with the wrong | • Turn both faucets on fully. |
temperature water. | • Make sure the temperature selection is correct. |
| |
| • Make sure the hoses are connected to the correct faucets. |
| Flush water lines. |
| • Disconnect the hoses and clean the screens. The hose filter screens |
| may be plugged. |
| • As your Washer is filling, the water temperature may change as |
| the automatic temperature control feature checks incoming water |
| temperature. This is normal. |
| • While your Washer is filling, you may notice just hot and/or just |
| cold water going through the dispenser when you have selected |
| cold or warm wash temperatures. This is a normal function of the |
| automatic temperature control feature as your Washer determines the |
| temperature of the water. |
|
|
Door locked or will not | • Press the Start/Pause Button to stop your Washer. |
open. | • It may take a few moments for the door lock mechanism to |
| |
| disengage. |
|
|
Does not drain and/or spin. | • Check the fuse or reset the circuit breaker. |
| • Straighten the drain hoses. Eliminate kinked hoses. If there is a drain |
| restriction, call for service. |
| • Close the door and press the Start/Pause Button. For your safety, |
| your Washer will not spin unless the door is closed. |
|
|
Load is too wet at the end | • Use the High or Extra High spin speed. |
of the cycle. | • Use high efficiency detergent to reduce |
| |
| • The Load is too small. Very small loads (one or two items) may |
| become unbalanced and not spin out completely. |
|
|
Leaks water. | • Make sure all hose connections are tight. |
| • Make sure the end of the drain hose is correctly inserted and secured |
| to the drainage system. |
| • Avoid overloading. |
| • Use high efficiency detergent to prevent |
|
|
Has excessive suds. | • Use high efficiency detergent to prevent |
| • Reduce the detergent amount for soft water, small or lightly soiled |
| loads. |
| • |
|
|
05 troubleshooting
