![](/images/new-backgrounds/1248401/24840159x1.webp)
troubleshooting
INFORMATION CODES
The Washer may display information codes to help you understand what is occurring with your Washer better.
CODE SYMBOL | MEANING | SOLUTION | |
|
|
|
|
|
| Unbalanced load prevented your | Redistribute the load, press the Start/Pause |
|
| Washer from spinning. | Button. |
|
|
|
|
|
| Door is open when Washer is | Close the door tightly and restart the cycle. |
|
| running. | If the code reappears, call for service. |
|
|
| |
|
|
|
|
|
| Your Washer failed to lock the | Close the door tightly and restart the cycle. |
|
| door. | If the code reappears, call for service. |
|
|
| |
|
|
|
|
|
| Water temperature control | Call for service. |
|
| problem. |
|
|
| (Heater Control problem) |
|
|
|
|
|
|
| Your Washer has tried to fill but | Call for service. |
|
| has not reached the proper water |
|
|
| level. |
|
|
|
|
|
|
| The door will not unlock. | Make sure the door is firmly closed. |
|
|
| Push the Power button to turn off your Washer, |
|
|
| then turn it on again. If the code reappears, call |
|
|
| for service. |
|
|
|
|
|
| Motor not running properly. | Restart the cycle pressing the Start/Pause |
|
|
| Button. If the code reappears, call for service. |
|
|
|
|
|
| Your washer is not draining. | Do the following: |
|
| It can also mean that the unit | 1) Turn off the unit and turn it on again. |
|
| senses a small clog while draining. | 2) Select only the Spin Cycle. |
|
|
| 3) Press the Start/Pause to drain the water. |
|
|
| If it still does not drain, call for service. |
|
|
|
|
|
| Your Washer has tried to fill but | Make sure the water faucets are open all the |
|
| was unsuccessful. | way. Check for kinked hoses. |
|
|
| Check the inlet screens on the fill hoses. |
|
|
| If you use a Flood Safety Device, then please |
|
|
| remove the device and connect the water hoses |
|
|
| directly to the unit. |
|
|
|
|
|
| Check if the hot water supply | You must connect the hot water supply hose |
|
| hose is connected. | because hot water is supplied by the Auto |
|
|
| Temperature Control (A.T.C.) function. |
|
|
|
|
|
| The hot/cold water hose | Please connect the hot/cold water hose |
|
| connection is not correct. | connection correctly. |
|
|
|
|
|
| A fault is detected in the water | Call for service |
|
| ||
|
| level sensor. |
|
|
|
|
|
|
| Jammed Key. | Call for service |
|
|
|
|
|
| Temperature sensor problem. | Restart the cycle. |
|
|
| If the code reappears, call for service. |
|
|
|
|