Problem |
| Action |
|
| |
|
|
|
| ||
| • Fully open both taps. |
|
| ||
| • Make sure the temperature selection is correct. |
| |||
| • Make sure the hoses are connected to the correct taps. Flush | ||||
|
| water lines. |
|
| |
| • Make sure the water heater is set to supply a minimum | ||||
|
| 120 °F (49 °C) hot water at the tap. Also, check the water | |||
|
| heater capacity and recovery rate. |
|
| |
Fills with the wrong | • | Disconnect the hoses and clean the mesh filter. The | mesh | ||
| filter may be clogged. |
|
| ||
water temperature. |
|
|
| ||
• | While the washing machine fills, the | water temperature may | |||
| |||||
|
| change as the automatic temperature control feature checks | |||
|
| incoming water temperature. This is normal. |
| ||
| • | While the washing machine fills, you | may notice just | hot and/ | |
|
| or just cold water going through the dispenser when cold or | |||
|
| warm temperatures are selected. This is a normal function | |||
|
| of the automatic temperature control feature as the washing | |||
|
| machine determines the water temperature. |
| ||
|
|
| |||
| • Use the High or Extra High spin speed. |
| |||
Load is wet at the | • | Use high efficiency (HE) detergent to reduce oversudsing. | |||
• Load is too small. Small loads (one or two items) may become | |||||
end of a cycle. | |||||
| unbalanced and not spin completely. |
|
| ||
|
|
|
| ||
| • Make sure the drain hose is not kinked or clogged. |
| |||
|
|
| |||
| • Make sure the door is properly closed. |
| |||
| • Make sure all hose connections are tight. |
| |||
Leaks water. | • Make sure the end of the drain hose is correctly inserted and | ||||
| secured to the drain system. |
|
| ||
|
|
|
| ||
| • | Avoid overloading. |
|
| |
| • | Use high efficiency (HE) detergent to | prevent oversudsing. | ||
|
| ||||
| • Excessive suds collect in recesses and can cause foul odours. | ||||
Has odours. | • Run cleansing cycles to sanitise periodically. |
| |||
• Clean the door seal (diaphragm). |
|
| |||
|
|
| |||
| • Dry the washing machine interior after a cycle has finished. | ||||
|
|
|
|
| |
No bubbles are seen | • Overloading may screen bubbles. |
|
| ||
(Bubbleshot models |
|
| |||
• Severely contaminated laundry may not generate bubbles. | |||||
only). | |||||
|
|
|
| ||
|
|
|
|
| |
Troubleshooting
