Sansui HDLCDVD220 To connect the TV/DVD to a PC Personal Computer, To return to normal mode

Connections	to other equipment	(continued)
To connect the TV/DVD	to a camcorder, or a TV Game
To playback from a camcorder, connect the camcorder to the unit as shown.

This unit can also be used as a display device for many video games. However, due to the wide variety of signals generated by these devices and subsequent hook-up variations required, they have not all been

included		in the suggested connection		diagrams.	You'll need to consult each		component's Owner's Manual for
additional		information.
Rear	of	the	unit
I	@	@	_To_VIDEO/AUDIO	IN		To Audio/VideoO_T	]	or [TVGAME]
[]	@	@	__:_	AudioNideocord
	@	@		(not supplied)

To connect the TV/DVD to a PC (Personal Computer)

Before you connect this TV/DVD to your PC, change the adjustment of your PC'sResolution and Refresh rate (60 Hz).

Connect one end of a (male to male) VGA cable to the video card of the computer and the other end to the VGA connector PC MONITOR on the rear of the TV/DVD. Attach the connectors firmly with the screws on the plug. In case of a Multimedia computer, connect the audio cord to the audio output of your Multimedia computer and to the AUDIO connector of the PC/DVI AUDIO IN jack of the TV/DVD.

Press INPUT SELECT on the remote control to select PC mode.

Switch on the computer. The TV/DVD can operate as the computer monitor.

	Rear of the	unit				Monitor	Display modes
						MODE	Resolution	Refresh rate
						VGA	640x480	60Hz
		_	To PC/DVI			VGA	720x400	70Hz
		_	AUDIO IN	t		SVGA	800x600	60Hz
ToPC				_	_'
						XGA	1024x768	60Hz
MONITORI				_
						WXGA	1280x768	60Hz
IN	/		Audi°e°rd(n°tsupplied)	f	_	WXGA	1280x720	60Hz
			VGA cable (not supplied)			WXGA	1360x768	60Hz
						To return to normal mode
						Press	INPUT SELECT	again.

NOTE:

•The on-screen displays will have a different appearance in PC mode than in TV mode.

•If there is no video signal from the PC when the unit is in PC mode, "No signal" will appear on the TV-screen.