Channel setup
This TV is equipped with a channel memory feature which allows channels to skip up or down to the next channel set into memory, skipping over unwanted channels. Before selecting channels, they must be programmed into the TV’s memory. To use this TV with an antenna, set the signal type option to the Air mode. When shipped from the factory, this menu option is in the Cable mode.
Air/Cable selection
1 Select “Channel ⇒ Air/Cable”.
2 Press ◀ or ▶ to select “Air” or “Cable”.
Air - VHF/UHF channels
Cable - CABLE TV channels
Picture | Sound | Time | Setup | Lock | Channel |
Air/Cable |
|
| Cable |
|
|
Auto Scan |
|
|
|
|
|
Channel List |
|
|
|
|
|
Show/Hide |
|
|
|
|
|
Channel Number |
| 23 |
|
| |
Channel Label |
|
|
| ||
|
|
|
|
|
|
NOTE:
• It may take a few seconds for a digital channel picture to appear on screen after being selected.
Auto Scan
1 Select “Channel ⇒ Auto Scan”, then press ▶ or
ENTER.
Picture | Sound | Time | Setup | Lock | Channel |
Are you sure to Auto
Scan?
No Yes
2 In confirmation window, Press ▶ to select “Yes”, then press ENTER. The TV will begin memorizing all the channels available in your area.
• It may take from 15 minutes to 30 minutes to complete memorizing digital cable channels. Depending on the reception condition, a bar display may not advance for several minutes, please be patient.
• If you press MENU during search, digital channel search will stop.
NOTE:
•Memorizing channels is best accomplished during evening “PRIMETIME” hours, as more stations are broadcasting digital signals. Memorizing channels can only be accomplished while a station is broadcasting a digital signal to set that channel into memory.
•If you are unsure of the digital channels available in your area, you may visit www.antennaweb.org to
receive a list based on your address or zip code. Should you require further assistance you may call our
• New digital channels may be added to your area periodically, it is recommended to perform the “Auto Scan” procedure regularly.
3 The new channel will be added into the channel memory.
Show/Hide channel
You can select the channel that you want to skip.
1 | Select “Channel ⇒ Show/Hide”, then press ▶ or | |||||||
ENTER. |
|
|
|
|
|
| ||
2 toPressskip.▲ or ▼ to select the channel that you want | ||||||||
|
| Picture | Sound | Time | Setup | Lock | Channel |
|
|
| Channel | Channel Label |
| Hide |
|
| |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
| ||
|
|
|
|
|
| |||
|
|
|
|
|
| |||
|
|
|
|
|
| |||
|
|
|
|
|
| |||
|
| Prev |
| 1/1 |
|
| Next | |
3 Press ENTER to assign P mark for unwanted channel.
4 Repeat steps 2 - 3 for other channels you want to show/hide.
EN 20
