Sanyo CLT-2419 Battery setup, Telephone line connection, Tone/pulse setting, Mounting on a wall

CLT-2419-2423E-NEW 3/14/03 3:32 PM Page 6

GETTING STARTED

GETTING STARTED

Battery setup

1.Remove the battery compartment cover on the handset, insert the battery, plug the cord into the jack (inside the compartment) and replace the cover.

2.Set the handset RINGER switch to ON, and place handset in the base.

3.Plug the AC adpator into the POWER DC 12V jack on the back of base and the other end into an electrical outlet. The CHARGE/PAGE indicator comes on verifying the battery is charging.

Charge the handset for

12 continuous hours prior to first use. The initial battery charge is important for best performance.

Note: It is normal for the handset and base to get warm when the handset is charging in the base.

Note: For desktop charging only, the

handset is able to charge facing up or down.

Telephone line connection

4.Plug the telephone line cord into the TEL LINE the base and into a modular phone jack.

Tone/pulse setting

1

1 2 3

jack on the back of

Mounting on a wall

Do not attempt to wall-mount the phone before initial 12-hour charging is completed.

Follow steps 1– 3 above to charge the handset.

4.Remove the handset from the base and set

aside. Turn the base over and align the four slots on the bottom of the base with the four hook-tabs on the bracket.

5. Insert the hook-tabs into the slots and push up until the bracket snaps securely into place.

6.Plug the telephone line

cord into the TEL LINE jack on the back of the

base and into a modular phone jack.

Note: If you have PULSE (rotary) telephone line, set the PULSE/TONE switch on the back of the base to PULSE.

7.Slip the mounting holes over the wall plate posts and slide the unit down firmly into place. (Wall plate not included.)

8.Place the handset in the base.

Note: If desired, gather the extra AC adaptor cord and telephone line cord together, fasten with a wire tie, and store inside the wall mounting bracket.

5.If you have PULSE (rotary) telephone line, set the PULSE/TONE switch on the back of the base to PULSE. For touch-tone service line, do nothing as your phone has been set to TONE at factory. If you do not know which type of service you have, contact your local telephone company.

Caution: Use only the Sanyo AC adaptor (U120030D) that is supplied with this phone. Using another AC adaptor may damage the phone.

Digital Security System

Your cordless phone uses a digital security system to provide protection against false ringing, unauthorized access and charges to your phone line. When you place the handset in the base, the phone verifies its security code. After a power outage or battery replacement, you should place the handset in the base for about 20 seconds to reset the code.

6 7