Sanyo DSR-M814 Press the, the [ ] or, positions), ] button to set the, ] or [ ] button to select a, selection (you can set up to, When you have finished making the

e00_VDH_M814.book Page 42 Thursday, October 28, 2004 9:59 AM

				SCREEN SET MENU
6	Press the [	] or [ ] button to select a	7	When you have finished making the
	sensor operation position, then press			settings, press the [EXIT/OSD] button.
	the [ ] or [	] button to set the		The display returns to the normal screen.
	selection (you can set up to 20

positions).

You can set sensor operation positions at any screen position.

zMoving the cursor

Each time you press the [ ] button, the cursor moves from left to right in the top row. After the cursor has reached the end of the row, it moves from left to right in the row below.

You can press the [ ] button to move the cursor in the opposite direction.

Holding down the [ ] or [ ] button moves the cursor as follows:

LEVEL Set sensor position

zSetting sensor operation positions

Pressing the [] or [] button once enables the currently selected position (displays ). Pressing the [] or [] button again disables the setting (displays –).

Setting

example

Operation position setting example

If you set an area near the center of the screen, the sensor operates and recording starts when a moving subject near the center of the screen is detected.

To activate alarm recording when the motion sensor detects movement, display the <RECORDER MENU>, and set the “ALARM TRIGGER” in “ALARM REC MODE SET” to a setting other than “ALARM.” ( P.46)

SETTINGS

42