Sanyo KHS1852, KHS0951, KHS1251 instruction manual Remote Control Unit continued

		Remote Control Unit (continued)
Program button		For details, see “Setting theTimer”.
		Press this button to select the mode you want to program.
TIMER SELECT button		No display : The timer does not operate.
					: The air conditioner stops at the set time.
					: The air conditioner starts at the set time.
					: The air conditioner stops and starts, or starts and stops, at the
					set times every day.
MODE selector button		Use this button to select the AUTO, HEAT, DRY or COOL mode.
(AUTO)				: When this setting is selected, the air conditioner calculates the
				difference between the thermostat setting and the room temperature
				and automatically switches to the “COOL” or “HEAT” mode as
				appropriate.
(HEAT)				: The air conditioner makes the room warmer.
	(DRY)			: The air conditioner reduces the humidity in the room.
(COOL)				: The air conditioner makes the room cooler.
FLAP button		Press this button either to select to set the airflow direction to one of the six
		possible positions manually, or to select the sweep function, which moves
		the flap up and down automatically.
				: The airflow direction can be set manually. (six positions)
				: The flap moves up and down automatically.
	NOTE	When you press the FLAP button, the air flow direction will be changed one
		by one as follows.
				Swing
FAN SPEED selector button				: The air conditioner automatically decides the fan speeds.
				: High fan speed
				: Medium fan speed
				: Low fan speed
1 HR. TIMER button				: When you press this button, regardless of whether the unit is
(1-HOUR OFF TIMER)				operating or stopping, the unit operates for one hour and then
				shuts down.
ACL button (ALL CLEAR)		Puts the remote control unit into pre-operation status. Always press this
		button after replacing the batteries.
ADDRESS switch		• Change the address switch to prevent mixing of signals from remote control
			units when two Sanyo air conditioners are installed next to each other.
			Normally, the address switch is set to A. When switching the address, the
			remote control must be changed, and the jumper cables on the indoor unit
			board must be cut. For more information, please contact the dealer where
			you made the purchase.

•Normally, the tabs on the remote control unit should not be bent.

SENSOR button When you press this button (use a small-tipped object such as a ballpoint pen), the mark will appear at the display. And the room temperature is detected by the sensor which is built into the indoor unit and the air conditioner is controlled accordingly.

NOTE If the remote control is located near a heat source, such as a space heater or in direct sunlight, press the SENSOR button to switch to the sensor on the indoor unit.

NOTE

The remote control unit sends the temperature signal to the air conditioner regularly at five minute intervals. If the signal from the remote control unit stops for more than ten minutes due to the loss of the remote control unit or other trouble, the air conditioner will switch to the temperature sensor which is built into the indoor unit and control the room temperature. In these cases, the temperature around the remote control unit may differ from the temperature detected at the air conditioner’s position.

OI-351-9EG 9