1. Horizontal
CAUTION
2. Vertical
�
�
�
Adjusting the Airflow Direction
The horizontal airflow can be adjusted by moving the vertical vanes with your hands to the left or right.
When the humidity is high, the vertical vanes should be in the front position during the cooling or dehumidifying operation. If the vertical vanes are positioned all the way to the right or left, condensation may begin
to form around the air vent and drip down.
The vertical airflow can be adjusted by moving the flap with the remote control unit. Do not move the flap with your hands. Confirm that the remote control unit has been turned on. Use the FLAP button to set either the sweep function or one of the six airflow direction settings.
(The maximum capacity is obtained at the position at 4 .)
| 6 |
| 5 |
SWEEP | 4 |
COOL | 3 |
and | 2 1 |
DRY
SWEEP
HEAT
A. Sweep function
The flap starts moving up and down to deliver air over the sweep range.
B. Setting the airflow manually
Referring to the above illustration, use the FLAP button to set the airflow direction within the range used during the heating, cooling, or dehumidifying operation.
NOTE
•
•
The flap automatically closes when the unit is off.
During the heating operation, the fan speed will be very low and the flap will be in the horizontal position (position 6) until the air being blown out of the unit begins to warm. Once the air warms up, the flap position and fan speed change to the settings specified with the remote control.
CAUTION
•
•
Use the FLAP button on the remote control to adjust the position of the flap. If you move the flap by hand, the flap position according to the remote control and the actual flap position may no longer match. If this should happen, shut off the unit, wait for the flap to close, and then turn on the unit again; the flap position will now be normal again.
Do not have the flap pointed down during cooling operation. Condensation may begin to form around the air vent and drip down.
22 |
