Sanyo PLC-XF46N/E Fig-7, Fig-4, Fig-5, Fig-6

4	Remove Lens Cap on the rear (mounting side) of Projection Lens and mount Lens on the lens
	Attachment with 4 Screws. (Use screws attached on lens.)
	Connect the Lens Motor Lead connector to the socket on the right-top of the lens attachment.
	(Motor Driven Lens only.) See Fig. 5.
	LENS LOCK SCREW	LENS ATTACHMENT	LENS LOCK
			LEVER

				Fig-4
	DRIVER		Lens attachments For each lens.
	IN THE LENS			LENS ATTACHMENT
	Part No. (610 275 6029)		Lens Model No.
				TYPE No. (PART No.)
			LNS-W01, LNS-W01Z, LNS-W02Z,	Lens Attachment 01
			LNS-W03, LNS-T01, LNS-T01Z,	POA-LNA-01
			LNS-T02, LNS-T03, LNS-S02,
				(610 303 8742)
			LNS-S02Z, LNS-S03, LNS-M01Z,
			LNS-W04, LNS-W06
	LENS	LOCATE MOTOR	LNS-W02, LNS-M01	Lens Attachment 02
		ON RIGHT SIDE		POA-LNA-02
	ATTACHMENT
				(610 304 6228)
		SOCKET
		CONNECTOR
5	LENS MOTOR LEAD		Fig-5
	Grasp (release lock) the Lens Lock Lever and turn it fully upward. (See Fig. 6.)
	Install the Lens into the projector. Grasp the Lens Lock Lever and turn the Lever fully downward until				E
	lever is Locked (clicked position) properly. (See Fig. 7.)
	When installing the Motor Driven Lens, be sure to mount Lens Motor on right side. (See Fig. 4.)
	After installing the lens, make sure the Lens is not loose and properly installed.
	LENS LOCK RELEASE		LENS LOCK
Grasp (unlock)			Grasp (unlock)
Lens Lock Lever			Lens Lock Lever
and pulling			and fully pulled
upward.			downward until it is
			locked (clicked).

Fig-6 Fig-7

- 3 -