Sanyo PLC-XF71 owner manual Terminals and Connectors

Part Names and Functions

Terminals and Connectors

		q	w
				e
				r
t	y	u	i	✽

qSERIAL PORT IN TERMINAL

If you control the projector by computer, you must connect a cable (not supplied) from your computer to this terminal.

wSERIAL PORT OUT TERMINAL

This terminal outputs signal from SERIAL PORT IN. More than two projectors can be controlled with one computer by connecting SERIAL PORT IN of another projector to this terminal.

eUSB CONNECTOR (Series B)

USB connector is to used to service the projector.

rR/C JACK

When using the wired remote control, connect the wired remote control to this jack with a remote control cable (not supplied).

[RESET button

A built-in micro processor which controls this unit may occasionally malfunction and need to be reset. This can be done by pressing the RESET button with a pen, which will shut down and restart the unit. Do not use the RESET function excessively.

tDVI INPUT TERMINAL

Connect computer output (Digital/DVI-D type) to this terminal. (p.20)

HD (HDCP Compatible) signal can be also connected. (p.21)

yD-sub 15-PIN INPUT TERMINAL

Connect computer output (Analog D-sub 15-pin type) to this terminal. (p.20)

u5 BNC INPUT JACKS

Connect the component or composite video output signal from video equipment to VIDEO/Y, Pb/Cb, and Pr/Cr jacks or connect the computer output signal (5 BNC Type [Green, Blue, Red, Horiz. Sync, and Vert. Sync.]) to G, B, R, H/V, and V jacks (pp.20–21).

iS-VIDEO INPUT JACK

Connect the S-VIDEO output signal from video equipment to this jack (p.21).

11