Sanyo PLC-XP100L, PLC-XP100BKL owner manual Part Names and Functions, Rear Terminal

Part Names and Functions

Rear Terminal

	!0
q	]
w	o
e	[
r	i
t	u
	y

qCOMPUTER INPUT TERMINAL (DIGITAL) Connect the computer output digital signal to this terminal. The HDTV (HDCP compatible) signal can also be connected (pp.20-21).

wCOMPUTER INPUT TERMINAL (ANALOG) Connect the computer (or RGB scart) output signal to this terminal (pp.20-21).

e5 BNC INPUT JACKS

Connect the component or composite video output signal from video equipment to VIDEO/Y, Pb/Cb, and Pr/Cr jacks or connect the computer output signal (5 BNC Type [Green, Blue, Red, Horiz. Sync, and Vert. Sync.]) to G, B, R, H/V, and V jacks (pp.20– 21).

rVIDEO INPUT JACK

Connect the component or the composite video output signal from video equipment to this jack (p.21).

tR/C JACK

When using the wired remote control, connect the wired remote control to this jack with a remote control cable (not supplied).

yUSB CONNECTOR (Series B)

Use this connector when controlling a computer with the remote control of the projector. Connect the USB terminal of your computer to this connector with the supplied USB cable (p.20).

uCONTROL PORT CONNECTOR

When controlling the projector from a computer, connect the computer to this connector with a control cable (p.20).

iS-VIDEO INPUT JACK

Connect the S-VIDEO output signal from video equipment to this jack (p.21).

oMONITOR OUT TERMINAL

This terminal can be used to output the incoming analog RGB signal from INPUT 1-3 terminal to the other monitor (pp.20-21).

!0Infrared Remote Receiver (Back)

The infrared remote receiver is also located in the front (pp.10, 15).

]Kensington Security Slot

This slot is for a Kensington lock used to deter theft of the projector.

*Kensington is a registered trademark of ACCO Brands Corporation.

[RESET button

A built-in micro processor which controls this unit may occasionally malfunction and need to be reset. This can be done by pressing the RESET button with a pen, which will shut down and restart the unit. Do not use the RESET function excessively.

11