Setting
Ceiling
When this function is "On", the picture is top/bottom and left/right reversed. This function is used to project the image from a ceiling mounting the projector.
Rear
When this function is "On", the picture is left/right reversed. This function is used to project the image to a rear projection screen.
Input search
This function detects the input signal automatically. When finding a signal, the search will stop. Use the Point ŻŹ buttons to select one of the following.
Off. . . . . Input search does not work.
On1. . . . Input search works under the situation below.
•When pressing the INPUT button on the top control.
•When pressing the COMPUTER button or
VIDEO button on the remote control.
On2. . . . Input search works under the situation below.
•When turning on the projector with pressing the POWER
•When pressing the COMPUTER button or VIDEO button on the remote control.
•When missing the current input signal. *
•When pressing the INPUT button on the top control.
Ceiling
Rear
*If the No show or Freeze function is active, cancel it to activate the Input search. It is also unavailable when
9Note:
•While Input search is set On1 or On2, the status of Input and Lamp are displayed every time the signal is switched.
•Only the input source selected at the last time can be detected.
•If any of the INPUT button on the top control or COMPUTER/VIDEO button on the remote control is pressed while Input search is on, Input search will stop and go back to the previous input signal.
45
