Setting

Capture

This function is used to capture the image being projected and use it for a starting-up display or interval of presentations. After capturing the projected image, go to the Logo function and set it as “User”. Then the captured image will be displayed when turning on the projector next time or pressing the MY PICTURE (MY-P) button on the remote control. (p11, 20)

To capture the image, select [Yes]. To cancel the Capture function, select [No].

 

Mounting

This function is used to select the way of setting the projector.

Off

···· Cancels the selected way of setting

Ceiling

···· Used to project the image from a ceiling mounting the

 

projector. The picture is top/bottom and left/right

 

reversed.

Wall

···· Used to project the image from a wall-hanging projector.

 

The picture is top/bottom reversed.

Rear

When this function is “On,” the picture is left/right reversed. This function is used to project the image to a rear projection screen.

Power management

For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the input signal is interrupted and no button is pressed for 30 seconds or more.

When the input signal is interrupted and no button is pressed for 30 seconds or more, the timer display with the message "No signal" appears on the screen. The count-down starts for 5 minutes.

When the count-down time has elapsed, the lamp will be turned off to cool itself down. The POWER indicator is flashing red during this cooling -off period. The next performance depends on setting as follows.

On ··· When the lamp has been fully cooled down, the POWER indicator changes to green flashing. In this condition, the projection lamp will be turned on if the input signal is reconnected or any button on the top control or remote control is pressed.

Off ··· The Power management function is canceled.

Power off confirmation

The confirmation dialog box to turn off the projector is displayed with this function ON.

Note:

A signal from a computer can be captured up to XGA(1024 x 768). If selecting 1280 x 1024 at Display area in the PC Adjust Menu (p36), then the image cannot be captured.

A signal from video equipment can be captured except for 720P, 1035i, 1080i.

If the Capture function fails to capture an image, the On-Screen Menu returns to the Capture item.

If capturing a signal which is not able to be captured, an exclamation mark appears and the function will not be available.

If cancelling the Capture function in the middle of operation, the last captured image will be deleted.

Capture

Mounting

Ceiling

Wall

Rear

This arrow indicates that there are previous items. Select this item and press the Point Up button to go to the previous item.

Power management

Time left until lamp off

Setting

41