Maintenance and Cleaning

Lamp Replacement

When the life of the projection lamp of this projector draws to an end, the LAMP REPLACE indicator lights yellow. If this indicator lights yel- low, replace the lamp with a new one promptly.

This indicator lights yellow when the life of the projection lamp draws to an end.

Top Control

POWER

WARNING

LAMP

REPLACE

CAUTION

Allow a projector to cool, for at least 45 minutes before you open the Lamp cover. The inside of the projector can become very hot.

CAUTION

For continued safety, replace with a lamp of the same type. Do not drop a lamp or touch a glass bulb! The glass can shatter and may cause injury.

Follow these steps to replace the lamp.

1

Turn off the projector and disconnect the AC plug. Allow the

 

projector to cool for at least 45 minutes.

2

Turn over the projector. Loosen the screw with a screwdriver,

 

and remove the lamp cover.

3

Loosen 2 screws of the lamp with a screwdriver and pull out the

 

lamp by grasping the handle.

4

Replace the lamp with a new one and tighten the 2 screws back

 

into position. Make sure that the lamp is set properly. Replace

 

the lamp cover and tighten the screw.

5

Connect the AC power cord to the projector and turn on the pro-

 

jector.

6

Reset the Lamp replace counter.

 

See “Lamp Replace Counter” on the next page.

Screw

Lamp Cover

Screw

Lamp

Handle

Screw

ORDER REPLACEMENT LAMP

Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.

Model No. of your projector

:

PLV-Z1X

Replacement Lamp Type No.

:

POA-LMP86

 

 

 

(Service Parts No. 610 317 5355)

46