Setting

Lamp mode

This function allows you to change brightness of the screen. Bright mode . . . . . . . . . Normal brightness

React image mode

. . . The controlled brightness according

 

with input signal

Theater black mode

. . . Lowers brightness and reduces the lamp

 

power consumption.

Remote control

This projector has two different remote control codes: Code 1 (initial code) and Code 2. This switching function prevents remote control interference when operating several projectors or video equipment together.

When operating the projector in “Code 1”, both the projector and the remote control must be switched to “Code 1”.

To change the code of the projector;

Set the remote control code in the Setting Menu to “Code 2”.

To change the code of the remote control;

Open the compartment lid on back of the remote control then you will find a white switch. Slide it left or right to change the code of the remote control.

After changing the code, make sure the remote control operates properly. To return to the initial code (Code 1), repeat the steps above.

Lamp counter reset

This function is used to reset the lamp replace counter. When replacing the projection lamp, reset the lamp replace counter by using this function. See page 47 for operation.

Factory default

This function returns all setting values except for the lamp counter to the factory default settings.

Cleaning

This function is used to clean inside of the projector. Using blower at the same time is more effective. (See p48, 49)

Press the SELECT button, then the projected image is blacked out temporary whether input source is selected or not.

To restore to normal, press any other buttons.

To cancel, press any other button during the cleaning operation.

Note:

When the batteries of the remote control are replaced, the remote control code automatically returns to the initial code (Code 1).

Lamp mode

Remote control

CODE1 CODE2

Remote control Code switch

Factory default

Select Factory default and this box appears. Select [Yes] , and the next box appears.

Select [Yes] to activate it.

42