Installation Procedure
Adjustment
1 Adjust the forward/backward slide (Adjustable range: 0 - 180 mm)
¡Loosen the four bolts on the top of the setting plate using a hexagon wrench (3 mm) and adjust the slider of setting plate. After the adjustment, tighten the four bolts which were loosened.
Bolts
0 - 7.09 inches |
(0 - 180 mm) |
2
3
Adjust the vertical slide (Adjustable range: +4° - –2°)
¡Remove the left and right cover plates.
¡Loosen the four bolts q located inside the setting plate using a hexagon wrench (6 mm).
¡Adjust the vertical slide with the two bolts w located inside the setting plate using a hexagon wrench (6 mm) (Adjust the left and right bolts so that their ends touch equally against the wall plate.)
¡Tighten the four bolts q which were loosened using the hexagon wrench (6 mm).
¡After adjustment, attach the left and right cover plates again.
Bolts q
4° 
Bolts w
2°
Adjust the horizontal rotation (Adjustable range: +5° - –5°)
¡Loosen the two bolts q located on the top of the setting plate using a hexagon wrench (3 mm).
¡Turn the adjustment knob w located on the left side of the setting plate to adjust the horizontal rotation.
¡Tighten the two bolts q which were loosened using the hexagon wrench (3 mm).
|
| Bolts q |
Adjustment knob w | 5° | 5° |
* “A” marks appear on the setting plate to indicate the locations of the bolts and adjustment knob.
7
10.9.8 11:21:14 AM
