Sanyo SAP-KRV123EH, SAP-KRV93EH Maintenance, Address Setting of the Remote Control Unit

8. MAINTENANCE

8-1. Address Setting of the Remote Control Unit

The address can be set in order to prevent interfer- ence between remote controllers when two Sanyo indoor units are installed near each other. The address is normally set to “A.” To set a different address, it is necessary to change the address on the second remote controller.

NOTE

Once changed, you cannot restore the original address setting of the air conditioner.

(1)Switch on the power source.

(2)Break the address-setting tab marked “A” on the second remote controller to change the address (Fig. 13). When the tab is removed, the address is automatically set to B (Fig. 14).

(3)Press and hold the remote controller QUIET but- ton and 1 HR TIMER button. At the same time, press the ACL (reset) button. Use a thin object such as the tip of a pen to press the ACL button. When this has been done, “oP-1” (test run) appears, blinking, in the remote controller clock display area.

(4)Each time the 1 HR TIMER button is pressed, the display changes as shown below. Press this but- ton 2 times to change the display to “oP-7” (address setting). (Fig. 15)

Test run mode

Self-diagnostic mode

Address setting mode

(5)“oP-7” has now been selected for address setting.

(6)Press the ON/OFF operation button on the remote controller. (Fig. 15) Check that the “beep” signal- received sound is heard from the second indoor unit (approximately 5 times). The sound you hear is the signal that the remote controller address has been changed.

(7)Finally press the remote controller ACL (reset) button to cancel the blinking “oP-7” display. (Fig. 15)

Changing of the second remote controller address is now completed.

Tab

Fig. 13

ACL button

Fig. 14

AIR CONDITIONER

UIET	ON•/OFF•	ON/OFF
		operation
QUIET		button
button
1HR.		1HR.
TEMP.		TIMER
		button
	MODE
FAN SPEED	NIGHT SETBACK
FLAP	HIGH POWER
TIMER
CANCEL	CLOCK
SENSOR	F 12H 24H	ACL
ADR	ACL

(Reset) button

Fig. 15

32