Sanyo TLS-9960 instruction manual Back Panel, RS485 B

LOCATIONS OF CONTROLS AND INDICATORS

Back Panel

1 2 3 H

A RS485 B

ADDRESS 485 TERMINATE ON ON

OFF232 OFF

EXT		WARNING TAPE		SW		ALARM
TIMER IN	COM	OUT	END OUT	OUT	COM	OUT	IN
CLOCK SET		SERIES OUT/	SERIES		TIMER	1 SHOT	ALARM
OUT	IN	NON REC OUT	IN	COM	OUT	IN	RESET IN

PUSH OPEN

		AUDIO		VIDEO
REMOTE	MIC IN	IN	OUT	IN	OUT
AC IN ~
RS232C

X
			W		V U T S R Q
Pin locations	Pin locations	4 5 6		7 8 9 F G
(femele) on the VCR	(male) on the VCR

			EXT		WARNING TAPE		SW		ALARM
			TIMER IN	COM	OUT	END OUT	OUT	COM	OUT	IN
		1	5
			CLOCK SET		SERIES OUT/	SERIES		TIMER	1 SHOT	ALARM
			OUT	IN	NON REC OUT	IN	COM	OUT	IN	RESET IN
1	6	6	9
NOTE:
Do not connect to			P O N M L K J I
phone line.

NOTE:

This terminal board may be damaged by 5kg-cm or more torque and using φ6mm-tip or more size screwdrivers.

1 RS485 A connector (RJ11 type)

2 RS485 B connector (RJ11 type)

3 DIP switches

œUsed when controlling the VCR through the RS485 or the RS232C connectors.

4 EXT TIMER IN (external timer input) terminal

5 COM (common) terminal

6 WARNING OUT (warning output) terminal

7 TAPE END OUT (tape end output) terminal

8 SW OUT (switch output) terminal

9 COM (common) terminal

F ALARM OUT (alarm output) terminal

G ALARM IN (alarm input) terminal

H Battery compartment

I ALARM RESET IN (alarm reset input) terminal

J 1 SHOT IN (single image recording trigger input) terminal

K TIMER OUT (timer recording output) terminal L COM (common) terminal

M SERIES IN (series recording trigger input) terminal

N SERIES OUT/NON REC OUT (series recording trigger output/non recording output) terminal

O CLOCK SET IN (external clock set trigger input) terminal

P CLOCK SET OUT (external clock set trigger output) terminal

Q VIDEO OUT (video output) jack

R VIDEO IN (video input) jack

S AUDIO OUT (audio output) jack

T AUDIO IN (audio input) jack

U MIC IN (microphone input) jack

V REMOTE (remote control input) jack W RS232C connector (D-sub 9-pin type) X AC power input

English 5