Display (Remote Control Unit)
When you first turn on the ON/OFF operation button, will blink on the display of the remote controller. During this blinking, the remote controller is verifying units connected. Use the remote controller, after stops blinking.
G
L
K
D
P
BF C I J M
N
A
O
E
H
Description
1 | A: When the unit is in the heating standby mode, the | indicator appears. (Refer to the description of the |
|
Special Remarks on page 12.)
B:The currently selected operation mode is displayed.
C:This is displayed when a different operation mode was already selected by another remote control unit and indicates that the mode cannot be changed.
D:When the TIMER SET button is pressed to set the timer, the indicator flashes.
E:The currently selected FAN SPEED is displayed.
F:The currently selected Airflow Direction and SWEEP status are displayed.
G:This is displayed only when an abnormality occurs within a unit.
H:When the CHECK button is pressed, the TEST indicator appears.
I:This is displayed to indicate that the system controller is being used for control.
When is flashing on the display, the operation is not accepted by the system controller.
J:This indicates the indoor unit address in case of group control. Unit No.
1 — 2
Indoor unit No.
Refrigerant circuit No.
K:This is displayed when it is time to clean the filter.
L:When setting the timer, the selected timer mode is displayed.
M:This indication appears when the temperature is set.
N:This indication appears when the remote control sensor is used.
O:This indication appears when the ventilation fan does not operate even if the ventilation button has been pressed.
P:This indication appears when the ventilation fan is operating.
1 - 8 |