Sanyo TM-SH80UG, SHA-KC64UG, RCS-SH80UG Programming shown below will cause Error setting

6.When setting the program operation erroneously

If the ERROR indicator blinks while you are setting program operation, take the following steps to correct times you set.

1While the blinks, the ON-time of the program operation that is incorrectly set also blinks.

2 Press the SET button to make the time to be corrected blink.

3 Correct the time using the HH or/and MM button.

4 Press the SET button. If the corrected time is acceptable, the turns off. 5 Press the PROGRAM button to complete the correction.

NOTE

Programming shown below will cause ERROR setting.

(1)Programmed operation periods overlap between programs. Example: ON-time OFF-time

(2)The OFF-time is earlier than the ON-time. Example: ON-time OFF-time

(3)The OFF-time and ON-time is the same. Example: ON-time OFF-time

0:00 23:59

ON OFF

ONOFF

0:00 23:59

OFFON

0:00 23:59

ON/OFF

3

(4)	Only the ON-time or OFF-time is programmed.
	Example: ON-time OFF-time	0:00					23:59
	(not programmed)		ON
The following examples will not cause ERROR setting.
(1)	The OFF-time is the same with the ON-time of the subsequent operation period.
	Example: ON-time OFF-time	0:00					23:59
			ON		OFF
				ON		OFF

(2)The programmed period is earlier than the preceding period. Example: ON-time OFF-time

By pressing the PROGRAM button, programs are arranged in order of time.
Example: ON-time OFF-time	0:00					23:59
				ON
					OFF
		ON	OFF

(3)Both the ON-time and OFF-time are 0:00. Example: ON-time OFF-time

*This program is for 24-hour continuous operation.

3 - 10 OI-432-03 - 10EG