Sanyo VCC-5974 1-2.VBS phase adjustment

1-2. VBS phase adjustment

1Connect a VBS signal source to the VBS IN connector on the camera.

The on-screen setting will automatically switch to VBS. Press the CURSOR (j or l) button to select the on-screen VBS setting (get it flashing), then press the SET button. The adjustment

sub-menu “ADJUSTMENT FOR VBS” will be displayed.

CURSOR

SET	MENU FOR ADJUSTMENT
	SYNC	VBS
	IRIS	AI
	BLC	ON

2Press the CURSOR (d or c) button to adjust the horizontal phase (H). The on-screen marker (b) will move and the adjustment value will flash according to the horizontal phase setting.

When finished setting the horizontal phase (H), press the CURSOR (l) button to select the sub-carrier (SC) phase.

3Press the CURSOR (d or c) button to adjust the sub-carrier (SC) phase. The on-screen marker (b) will move and the adjustment value will flash according to the sub-carrier phase setting.

Note:

When an adjustment is made, the PRESET setting will automatically switch to OFF. To return to the initial values, just return the PRESET setting to ON, then press the SET button.

4When finished.

(Refer to step 3 on page 15.)

Note:

If using a VS sync signal, the H sync phase adjustment is made by following the same method as described for the “VBS phase adjustment”.

ADJUSTMENT FOR VBS

(PHASE)

H	o------	z------	p	280
SC	o------	z------	p	90

16 English