PARTS NAMES

1

13

2 4

2

76543

8

1 2 3 2

1

1Shorter screws: M3 x 4

2Longer screws: M3 x 6

3Camera mounting screw hole: 1/4"-20 UNC

1Lens iris output connector (4 pin)

This 4-pin connector is used to send the DC control signal and power supply to an auto-iris type lens.

2Auto white balance push lock button (AWB LOCK)

3Menu setting button (SET)

Connect the camera to the monitor, then press the SET button for about 3 seconds to display the on-screen menu.

4Cursor button (CURSOR)

j: Press this button to move the cursor up.

c: Press this button to move the cursor to the right, or to turn the settings ON/OFF etc.

d: Press this button to move the cursor to the left, or to turn the settings ON/OFF.

l: Press this button to move the cursor down.

5Flange-back lock screw (FLANGE BACK LOCK)

6Flange-back adjustment screw (FLANGE BACK ADJ.)

7Lens mount cap

The cap is installed to protect the lens mount section.

Remove the lens mount cap before installing a lens (sold separately).

8Camera installation bracket

The bracket can be fixed at the top or bottom of the camera. When fixing the bracket, be sure to use the longer screws and install the shorter screws on the opposite side to seal the openings.

CAUTION:

When installing the camera support, select a location that can support the total weight of the camera and accessories.

4 English