PREFACECL SERIES “e” PRINTER OPERATOR’S MANUAL
The CL Series “e” Printer Operator’s Manual contains basic information about the
printer such as setup, installation, cleaning and maintenance. It also contains
complete instructions on how to use the operator panel to configure the printer. The
following is a brief description of each section in this manual.
SECTION 1. PRINTER OVERVIEW
This section contains a discussion of the printer specifications and optional
features.
SECTION 2. INSTALLATION
This section contains instructions on how to unpack and set up the printer,
AND load the labels and ribbon.
SECTION 3. CONFIGURATION
This section contains instructions on how to use the operator panel to
configure the printer.
SECTION 4. CLEANING AND MAINTENANCE
This section contains instructions on how to clean and maintain the printer.
SECTION 5. PROGRAMMING
This section has been replaced by the “e” and PRO Printer Programming
Reference, PN 9001096 on the Printer Utilities CD-ROM. It introduces the
SATO printer programming language. It contains the commands that are used
with the printer to produce labels with bar codes, alphanumeric data and
graphics.
SECTION 6. INTERFACE SPECIFICATIONS
This section contains the printer’s interface specifications, which include
detailed information on how to properly interface your printer to the host
system.
SECTION 7. TROUBLESHOOTING
This section contains troubleshooting procedures to follow in the event you
have printer problems.
SATO CL “e” Series Printers PN 9001074 Rev. B Page - i