DEFAULT SETTINGS
SWITCH SELECTIONS
All switches are placed in the Off default position for shipping. This will result in the
following operating configuration:
Communications:
Protocol:
Sensor:
Receive Buffer:
Mode:
Label Sensor:
Backfeed:
External Signals:
8 data bits, no parity, 1 Stop bit, 9600 Baud(1)
Ready/Busy
Gap Sensor
Multi Job
Batch/continuous
Sensor Used
Enabled
Enabled
(1) Only if RS232 I/F Module is installed.
SOFTWARE DEFAULT SETTINGS
The printer stores the software settings upon receipt and uses them until they are
again changed by receipt of a command containing a new setting. These settings are
stored in non-volatile memory and are not affected by powering the printer off. The
printer may be reset to use the default software settings by depressing the LINE and
FEED keys simultaneously while powering the printer on. You will be asked to
confirm that you want the printer default settings by selecting either YES or NO by
using the LINE key to step the cursor to the desired setting. If you select YES and
press the FEED key, the following default configuration will be stored:
CL408e CL412e CL608e CL612e
Print Darkness 3 2
Print Speed 4 in. per sec. 6 in. per sec.
Print Reference Vertical = 0000, Horizontal = 0000
Zero Slash
Auto On Line Enabled
Once the default operation is completed, a DEFAULT COMPLETED message will be
displayed on the LCD panel or a single beep will be heard if the printer does not have
an LCD panel. The printer should be powered off while this message is being
displayed (or after the beep is heard. This saves the default settings in the
non-volatile memory where they will be automatically loaded the next time the
printer is powered on.
Page 3-6 PN9001074 Rev. B SATO CL Series “e” Printers
Section 3. Configuration