SATO 408e manual Configuration, Printer Set Up

Section 3. Configuration

Stop Bit Selection (DSW1-4). Selects the number of stop bits to end each byte

transmission.

DSW1-4	SETTING
Off	1 Stop Bit
On	2 Stop Bits

DSW1

ON

OFF

1 2 3 4 5 6 7 8

Baud Rate Selection (DSW1-5,DSW1-6). Selects the data rate (bps) for the

RS232 port.

DSW1-5	DSW1-6	SETTING					DSW1
Off	Off	9600	ON
Off	On	19200	OFF
On	Off	38400
				1	2	3	4	5	6	7	8
On	On	57600

Protocol Selection (DSW1-7,DSW1-8). Selects the flow control and status reporting protocols. See Section 6: Interface Specifications for more information.

(* Will select protocol for M-8400 if DSW2-8 is ON)

DSW1-7	DSW1-8	SETTING					DSW1
Off	Off	Rdy/Bsy	ON
Off	On	Xon/Xoff	OFF
On	Off	Bi-Com 3
				1	2	3	4	5	6	7	8
On	On	Bi-Com 4*

Printer Set Up

Print Mode Selection (DSW2-1). Selects between direct thermal printing on thermally sensitive paper and thermal transfer printing using a ribbon.

DSW2-1	SETTING
Off	Therm Xfr
On	Direct Therm

DSW2

ON

OFF

1 2 3 4 5 6 7 8

Sensor Type Selection (DSW2-2). Selects between the use of a label gap or a

reflective Eye-Mark detector.

DSW2-2	SETTING
Off	Gap
On	Eye-Mark

DSW2

ON

OFF

1 2 3 4 5 6 7 8

Page 3-2 PN 9001074 Rev. B SATO CL Series “e” Printers