Changing Key Operator Settings
147
8
Note
You can program up to 24 charac-
ters for the sender.
You can check Own Name and Own
Fax Number with Journal. You can
check programmed Special Senders
with specified sender list.
p.155
Printing the Special Sender List
If you select "OFF" for the Special
Sender function in "Initial Set Up",
the settings will be the same as the
"Reception Mode" p.131 settings.
Authorized Reception
Use this feature to limit incoming
senders. The machine only re-
ceives the faxes from programmed
Special Senders, and therefore, it
helps you screen out unwanted
messages, such as junk mail, and
save you from wasting fax paper.
Note
To use this feature, program the
Special Senders, and then select
"ON" in "Authorized RX" with
"Reception Mode".
p.131 Re-
ception Mode You can choose
whether this feature is turned on.
Set this with the User Parame-
ters.
p.141 Changing the User
Parameters (Switch08, Bit2)
Without programming Special
Senders, the Authorized RX
function will not work even if
you select "ON".
You can select whether to receive
only from programmed senders
or receive only from senders oth-
er than the ones programmed
with "User Parameters".
p.141
Changing the User Parameters
(Switch08, Bit2)
If you select "OFF" for Author-
ized RX in "Initial Set Up", the
settings will be the same as the
"Reception Mode" settings.
Forwarding
Use this feature to print received
messages, and then transfer them
to receivers which are pro-
grammed beforehand. Only faxes
sent by programmed senders (Spe-
cial Senders) will be received.
Thus, paper will not be wasted for
printing unnecessary faxes. Re-
ceiving faxes sent only by senders
not programmed as Special Send-
ers is also possible.
Note
To use this feature, program
your Special Senders, and then
select "ON" for "Forwarding" in
"Reception Mode". p.131 Re-
ception Mode
If you specify "ON" in "Forward-
ing" and select "Same as basic
settings", the fax message will be
forwarded to the other ends pro-
grammed in "Specify end Re-
ceiver". p.136 Forwarding
If you do not program any Spe-
cial Senders, the machine trans-
fers all incoming documents to
the other ends that is specified
in "Specify end Receiver".
RX File Print Qty
Use this feature to print the speci-
fied number of copies of docu-
ments received from programmed
senders (Special Senders). If you
do not program any Special Send-
ers, the machine prints the speci-
fied number of copies for all
received documents.
Limitation
You cannot use multi-copy print-
ing with Polling Reception, Con-
fidential Reception, or Memory
Lock.
Note
You can specify 1 to 10 copies.
RusC2FaxADEN-F_V4_FM.book Page 147 Monday, August 20, 2001 10:52 AM