Schumacher Troubleshooting, Problem, Reason, Solution, Specifications, 10.1, Model PI-70

3.Install a new fuse (10-amp for Model PI-70 and 15-amp for Models PI-120 and PI-140). The fuse can be found on the end of the plug on the inverter.

4.Do not tighten the fuse cap too tight; finger-tight is sufficient.

ATTENTION: Do not install a fuse higher than 10-amp for Model PI-70, and 15-amp for Models PI-120 and PI-140, as this may damage the inverter. Make sure to correct the cause of the blown fuse before using the inverter again.

9.Troubleshooting

PROBLEM	REASON	SOLUTION
LEDs do not light,	Poor contact at	Unplug and reinsert
or inverter does	terminals.	the 12-volt plug.
not function.	Fuse blown.	See “IF THE
		INVERTER FUSE
		BLOWS” section.
	Inverter shutdown.	See “LED
		INDICATOR AND
		SHUTDOWN
		PROTECTION”
		section.
	Inverter may not be	See Warranty and
	working properly.	call Customer Service
		1-800-621-5485
		(Hours: 7:00 am –
		5:00 pm CST).

10.	SPECIFICATIONS
10.1	Model PI-70:
Maximum Continuous Power		70	Watts
Surge Capability (Peak Power)		140	Watts
No Load Current Draw			<0.2A
Wave Form		Modified Sine Wave
Input Voltage Range		10.5V – 15.5V DC

• 7 •