Scientific Atlanta DPX213 manual

Install USB Drivers, Continued

Windows XP

Follow these steps to install the WebSTAR cable modem USB drivers for Windows XP environments.

1.Insert the USB Cable Modem Driver Installation Disk into the CD-ROM drive of your PC.

2.Wait until the Power and Cable indicators on the cable modem illuminate solid green; then, plug the USB cable into the USB port on your PC.

Result: The Found New Hardware Wizard window opens.

3.In the Found New Hardware Wizard window, select Install from a list or specific location (Advanced), then click Next.

4.In the Found New Hardware Wizard window, select Search removable media (floppy, CD-ROM), and then click Next.

Result: The Hardware Installation window opens.

5.In the Hardware Installation window, click Continue Anyway to continue the installation.

Result: The Found New Hardware Wizard window reopens with a message that the installation has finished.

6.Click Finish to close the Found New Hardware Wizard window.

Result: The USB drivers are installed on your PC and your cable modem is ready for use.

Note: If you cannot access the Internet, contact your cable service provider for further assistance.

24

WebSTAR Model DPX213 VoIP DOCSIS Cable Modem User's Guide

4001231 Rev A

Image 25

Scientific Atlanta DPX213 manual Result The Found New Hardware Wizard window opens

Contents

Model DPX213 VoIP Docsis Cable Modem Introduction OverviewThis Guide This Section Important Rules for Safe Operation Placement Cleaning the EquipmentRead and Retain These Instructions Important Rules for Safe Operation Power Sources Power Cord ProtectionDamage that Requires Service Grounding Section B Before You Begin Check Your Equipment Equipment Checklist Section C Front and Back Panel Components Front Panel Components WebSTAR Cable Modem Front Panel Back Panel Components WebSTAR Cable Modem Back Panel Initial Power Up, Calibration, and Registration Front Panel LED Status Indicator FunctionsNormal Operations Special Conditions Section D Internet Service Installation Before You Begin Contacting Your Local Cable Service ProviderSelecting a Location for Your Modem Minimum System Requirements for PCs System RequirementsMinimum System Requirements for Macintosh System Requirements for an Ethernet Connection Installation Diagram Install the Cable Modem Installing the Modem Configuring the TCP/IP Protocol for Windows 95/98/98SE//ME Configure TCP/IPWindows 95/98/98SE/ME Renewing the IP Address for Windows 95/98/98SE/ME Results Windows XP Windows Macintosh Windows 98/98SE/ME Install USB Drivers Windows Result The Found New Hardware Wizard window opens Frequently Asked Questions Frequently Asked Questions Common Troubleshooting Suggestions TroubleshootingModem does not register an Ethernet connection Modem does not register a cable connection Check and Correct Section E Telephone Service Installation Before You Begin Selecting a Location for Your Modem Telephone Requirements Telephone Wiring RequirementsNumber of Telephone Devices Telephone Device Types Installing the Cable Modem to Provide Telephone Service Install the Cable Modem to Provide Telephone Service Installation Diagram Installing the Cable Modem How many telephones can I connect? Can I use my existing phone number with the cable modem? There is no dial tone when I lift the telephone handset Disclaimer TrademarksDocumentation Copyright Notice Software Use Notice United States FCC Compliance FCC ComplianceFCC Declaration of Conformity Canada EMI Regulation If You Need Technical Assistance For Information