Seagate ST136403LW/LC manual How to install the drive, LW model installation

Cheetah 36 Installation Guide, Rev. A 17

How to install the drive

This installation guide provides step-by-step instructions to make your drive installation as easy as possible. Follow the installation steps listed for your drive model as listed below:

LW models (use the installation steps beginning below).

LC models (use the installation steps beginning on page 30).

LW model installation

1.Set the SCSI ID on the drive.

Determine which SCSI IDs are already being used in the system and then assign this disc drive a SCSI ID that isn’t already being used. Use the J6 connector located on the front of the drive to set the SCSI ID (see Figure 3).

• This drive is SCAM (SCSI Configured AutoMati-

cally) compliant. If you are installing this drive in a SCAM compliant system, you can skip this step because the system automatically assigns the drive SCSI

ID.

•The host system’s SCSI controller usually uses SCSI ID 7 so this SCSI ID is not usually available for disc drives or other devices.

•Most ST136403LW drives are factory set with the SCSI ID set at 0. If this is the only SCSI drive in your system and there are no other SCSI devices on the daisychain, you can leave this drive’s SCSI ID set to 0 and proceed to the next step. A device is any hardware other than an inline termina- tor that is connected to the SCSI cable.